Google
 

Trailing-Edge - PDP-10 Archives - SRI_NIC_PERM_SRC_1_19910112 - 7/documentation/reaper.doc
There are 18 other files named reaper.doc in the archive. Click here to see a list.
REAPER.DOC -- Version 6(301)
20-Jun-85

COPYRIGHT (C) 1984 BY
DIGITAL EQUIPMENT CORPORATION, MAYNARD, MASS.


THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY BE USED AND  COPIED
ONLY  IN  ACCORDANCE  WITH  THE  TERMS  OF  SUCH  LICENSE AND WITH THE
INCLUSION OF THE ABOVE COPYRIGHT NOTICE.  THIS SOFTWARE OR  ANY  OTHER
COPIES  THEREOF MAY NOT BE PROVIDED OR OTHERWISE MADE AVAILABLE TO ANY
OTHER PERSON.  NO TITLE TO AND OWNERSHIP OF  THE  SOFTWARE  IS  HEREBY
TRANSFERRED.

THE INFORMATION IN THIS SOFTWARE IS SUBJECT TO CHANGE  WITHOUT  NOTICE
AND  SHOULD  NOT  BE  CONSTRUED  AS  A COMMITMENT BY DIGITAL EQUIPMENT
CORPORATION.

DIGITAL ASSUMES NO RESPONSIBILITY FOR THE USE OR  RELIABILITY  OF  ITS
SOFTWARE ON EQUIPMENT WHICH IS NOT SUPPLIED BY DIGITAL.


1.0  SUMMARY

REAPER is a program that is run by the operator or a  privileged  user
to  mark  files  for  migration  to  tape.  This migration can be done
either on the basis of the age of the file, or  if  the  directory  is
over quota.

REAPER version 6(301) runs on TOPS-20 Release 6.

REAPER does not require any other software modules  during  execution.
However,  following  a  REAPER run, DUMPER must be run to copy to tape
any files that REAPER marked for migration.

REAPER is documented in the TOPS-20 Operator's Guide



2.0  EXTERNAL CHANGES

The TAKE command can have a SKIP command that references non-existant
directories;  the non-existant directories generate a warning message
and are otherwise ignored.

A new command, POLICY, exists.  It is equivalent to TAKE SYSTEM:REAPER.CMD.
It takes no arguments.

TAKE<CR> is now used to end a TAKE file silently.



3.0  KNOWN BUGS AND DEFICIENCIES

None.



4.0  INSTALLATION INSTRUCTIONS


4.1  Files Needed to Run REAPER

REAPER.EXE is the only file needed for REAPER execution.   It  may  be
desired  to  have a file called SYSTEM:REAPER.CMD that contains a list
of REAPER commands that are used by the installation.  This  file  can
be processed by giving the TAKE command to REAPER.


4.2  Instructions for Loading and Installing REAPER

REAPER is loaded in SYS: as part of the installation  procedure.   New
versions may be put into use by copying the REAPER.EXE file onto SYS:.


4.3  Files Needed to Build REAPER

REAPER is built from the following files:
     REAPER.MAC
     ARMAIL.MAC

In addition, the following files must be on SYS:

     MACREL.REL
     MONSYM.UNV
     MACSYM.UNV


4.4  Instructions for Building REAPER

SUBMIT REAPER.CTL/TIME/UNIQ:0/REST



5.0  INTERNAL CHANGES

Refer to REAPER.MAC for detailed information about changes.


6.0  SUGGESTIONS

None.