There are 3 other files named ucode.doc in the archive. Click here to see a list.
KL MICROCODE RELEASE DOCUMENT -- V2(400)
Digital Equipment Corporation, Maynard, Mass.
This software is furnished under a license for use only on a single
computer system and may be copied only with the inclusion of the above
copyright notice. This software, or any other copies thereof, may not
be provided or otherwise made available to any other person except for
use on such system and to one who agrees to these license terms.
Title to and ownership of the software shall at all times remain in
The information in this software is subject to change without notice
and should not be construed as a commitment by Digital Equipment
DEC assumes no responsibility for the use or reliability of its
software on equipment which is not supplied by DEC.
KL MICROCODE RELEASE DOCUMENT -- V2(400) Page 2
E400RG.DOC -- v2(400)
1. Microcode version 2(400) is the twelfth release of the KL10
microcode. Microcode version 2(400) appears as KLX.MCB
only. It supports a model B KL10 with or without MCA25 for
TOPS-10 V7.02 only. This is the seventh release of the
KL10 microcode that supports an 'Extended KL10' described
in the Hardware Reference Manual.
2. The KL10 microcode is not dependent on any monitor, but
because of hardware differences between the various -10
processors, a monitor must be built specifically for the
KL10. KL10 microcode version 2(400) has been tested with the
TOPS-10 release 7.02 monitor.
2.0 KNOWN DEFICIENCIES
KL MICROCODE RELEASE DOCUMENT -- V2(400) Page 3
3.0 RELATED DOCUMENTATION
The microcode is implicitly documented in the System Reference Manual,
in that it is an implementation of a PDP-10. The only other
documentation is in the listing and prints of the KL10 processor.