There are 7 other files named dc72np.doc in the archive. Click here to see a list.
Copyright (C) 1975,1976
Digital Equipment Corporation, Maynard, Mass.
This software is furnished under a license for use only on a single
computer system and may be copied only with the inclusion of the above
copyright notice. This software, or any other copies thereof, may not
be provided or otherwise made available to any other person except for
use on such system and to one who agrees to these license terms.
Title to and ownership of the software shall at all times remain in
The information in this software is subject to change without notice
and should not be construed as a commitment by Digital Equipment
DEC assumes no responsibility for the use or reliability of its
software on equipment which is not supplied by DEC.
DC72NP.DOC Page 2
This document reflects the software as of version 5.
The purpose of this release is to support the 6.02 release of the
TOPS10 monitor. The DC72NP code executes in a DC72NP remote station
for the DECsystem-10.
2.0 ASSEMBLING THE DC72NP CODE
DC72NP code is assembled from 2 files, C.PAL and DC72NP.PAL. C.PAL is
a configuration file which is supplied by the user. DC72NP is the
actual DC72NP source code.
2.1 C.PAL for a DC72NP
For a DC72NP a typical configuration file would be:
PDP8=2 /DEFINES THIS IS AN PDP8E
TTYN=20 /DEFINES THERE ARE 16 TTYS PLUS CTY
OURNNM=15 /DEFINES NODE NUMBER FOR DC72NP TO BE 15
DEFINE DC72ID "F;"O;"O> /DEFINES DC72NP NODE NAME
2.2 Assembling DC72NP code
Typical commands to assemble the DC72NP code are:
3.0 KNOWN BUGS AND DEFICIENCIES
4.0 INSTALLATION INSTRUCTIONS
Place the DC72NP binary file, which resulted from the assembly
described in 2.2 above, on SYS: and then load it into the DC72NP with
NETLDR. Typical command dialogues with NETLDR are given in
[End of DC72NP.DOC]