There are 5 other files named fe2.doc in the archive. Click here to see a list.
FE.DOC -- V2(47)
THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY ONLY BE USED
OR COPIED IN ACCORDANCE WITH THE TERMS OF SUCH LICENSE.
COPYRIGHT (c) DIGITAL EQUIPMENT CORPORATION 1977,1986.
ALL RIGHTS RESERVED.
FE2.DOC Page 2
FE is a utility for file transfers between the TOPS-10 file system and
the FILES-11 file system. It handles protocol for the "FE" device
such that FE: can be addressed as a FILES-11 device, usually through
*** CAUTION ***
The "FE" device is intended for use only
in software development and updating
procedures by knowledgeable people. Use
without proper caution may produce
FE runs under TOPS-10 Release 6.03 and RSX-10F Release V5J or later.
FE depends on the existance of the RSX-20F task T20ACP, which should
reside on the -11 file system as "T20ACP.TSK".
Use of FE and file conversion procedures are described in the Guide To
Using the "FE" Device, USEFE.MEM.
2.0 EXTERNAL CHANGES
3.0 KNOWN BUGS AND DEFICIENCIES
As of this document, there are no known bugs or deficiencies.
4.0 INSTALLATION INSTRUCTIONS
4.1 Files Needed to Run FE
FE consists of one file, FE.EXE, and requires the RSX-20F task file
"T20ACP.TSK" to exist on the -11 file system.
4.2 Instructions for Installing FE
Copy FE.EXE to SYS:.
FE2.DOC Page 3
4.3 Files Needed to Build FE
FE is built from the following files:
4.4 Instructions for Building FE
Type the following command:
4.5 Special Considerations
5.0 INTERNAL CHANGES
[End of FE2.DOC]