Trailing-Edge
-
PDP-10 Archives
-
k20v7b
-
manuals/usah20.doc
There are 16 other files named usah20.doc in the archive. Click here to see a list.
USAH20.DOC -- Version 3A(2)
October 1981
COPYRIGHT (C) 1978,1980,1982 BY
DIGITAL EQUIPMENT CORPORATION, MAYNARD, MASS.
THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY BE USED AND COPIED
ONLY IN ACCORDANCE WITH THE TERMS OF SUCH LICENSE AND WITH THE
INCLUSION OF THE ABOVE COPYRIGHT NOTICE. THIS SOFTWARE OR ANY OTHER
COPIES THEREOF MAY NOT BE PROVIDED OR OTHERWISE MADE AVAILABLE TO ANY
OTHER PERSON. NO TITLE TO AND OWNERSHIP OF THE SOFTWARE IS HEREBY
TRANSFERRED.
THE INFORMATION IN THIS SOFTWARE IS SUBJECT TO CHANGE WITHOUT NOTICE
AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY DIGITAL EQUIPMENT
CORPORATION.
DIGITAL ASSUMES NO RESPONSIBILITY FOR THE USE OR RELIABILITY OF ITS
SOFTWARE ON EQUIPMENT WHICH IS NOT SUPPLIED BY DIGITAL.
USH3A.DOC Page 2
USAH20.DOC -- Version 3A(2)
October 1982
1.0 SUMMARY
USAH20 is a general purpose downstream billing program with Category C
support. It uses the new USAGE file format (see DECSYSTEM-20 USAGE
File Specification for a complete description) as input and optionally
outputs four reports. These are:
1. System usage sorted by user name.
2. System usage sorted by account.
3. Disk usage sorted by directory name.
4. Disk usage sorted by account.
Read USAH20.HLP for instructions on running this program.
The released version of USAH20.EXE does not depend on any software.
However, if you wish to recompile this program, FORTRAN V5A and SORT
V4 or later will be needed.
2.0 EXTERNAL CHANGES
None.
3.0 KNOWN BUGS AND DEFICIENCIES
None.
4.0 INSTALLATION INSTRUCTIONS
4.1 Files Needed to Run USAH20
USAH20 consists of one file, USAH20.EXE. The input files needed are a
USAGE file and a file called USAG20.CHG which contains the rates.
USH3A.DOC Page 3
4.2 Instructions for Loading and Installing USAH20
Mount the tape labeled Tools Tape on MTA0: and type the following
commands:
R DUMPER
TAPE MTA0:
REWIND
DENSITY 1600-BPI
SKIP 11
RESTORE <*>USAG20.CHG (TO) SYS:*.*.-1,
*>USAH20.EXE (TO) SYS:*.*.-1
REWIND
4.3 Files Needed to Build USAH20
USAH20 is built from the following files:
USAH20.FOR
4.4 Instructions for Building USAH20
Mount the tape labeled Tools Tape on MTA0: and type the following
commands:
R DUMPER
TAPE MTA0:
REWIND
DENSITY 1600-BPI
SKIP 11
RESTORE <*>*.*.* (TO) <self>*.*.*
REWIND
^C
FORTRAN
USAH20,USAH20=USAH20
^C
LOAD USAH20
SAVE USAH20
USH3A.DOC Page 4
5.0 INTERNAL CHANGES
Refer to USAH20.TCO for detailed information of changes to USAH20.
6.0 SUGGESTIONS
Make a detailed report so that the items listed will be entry by
entry.
[End of USH3A.DOC]