Trailing-Edge
-
PDP-10 Archives
-
BB-4170G-SM
-
documentation/bot6-20.doc
There are 5 other files named bot6-20.doc in the archive. Click here to see a list.
BOOT.DOC -- Version 6(131)
September 1978
COPYRIGHT (C) 1976,1977,1978 BY
DIGITAL EQUIPMENT CORPORATION, MAYNARD, MASS.
THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY BE USED AND COPIED
ONLY IN ACCORDANCE WITH THE TERMS OF SUCH LICENSE AND WITH THE
INCLUSION OF THE ABOVE COPYRIGHT NOTICE. THIS SOFTWARE OR ANY OTHER
COPIES THEREOF MAY NOT BE PROVIDED OR OTHERWISE MADE AVAILABLE TO ANY
OTHER PERSON. NO TITLE TO AND OWNERSHIP OF THE SOFTWARE IS HEREBY
TRANSFERRED.
THE INFORMATION IN THIS SOFTWARE IS SUBJECT TO CHANGE WITHOUT NOTICE
AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY DIGITAL EQUIPMENT
CORPORATION.
DIGITAL ASSUMES NO RESPONSIBILITY FOR THE USE OR RELIABILITY OF ITS
SOFTWARE ON EQUIPMENT WHICH IS NOT SUPPLIED BY DIGITAL.
BOT6.DOC Page 2
BOOT.DOC -- Version 6(131)
September 1978
1.0 SUMMARY
BOOT is used to load the TOPS-20 Monitor from disk into KL10/KS10
memory. On normal system startup, BOOT is automatically loaded and
started by RSX20F, and will load the TOPS-20 Monitor without operator
intervention.
BOOT is also responsible for dumping KL10/KS10 memory after system
malfunction, for later analysis.
BOOT version 6(131) runs only with TOPS-20 Release 3A.
BOOT is documented in the following documents:
DECSYSTEM-20 Software Installation Guide
DECSYSTEM-20 Operator's Guide
2.0 EXTERNAL CHANGES
BOOT will load the DX20 microcode if a DX20 is present.
3.0 KNOWN BUGS AND DEFICIENCIES
BOOT will load the TOPS-20 Monitor from disk only.
4.0 INSTALLATION INSTRUCTIONS
4.1 Files Needed to Run BOOT
BOOT requires the file to be loaded, usually ps:<SYSTEM>MONITR.EXE, be
present on the disk. The default file is PS:<SYSTEM>MONITR.EXE.
4.2 Instructions for Loading and Installing BOOT
BOOT is distributed on the floppy diskettes containing the front-end
software. It is installed in the front-end area during system
installation, (see DECSYSTEM-20 Software Installation Guide).
BOT6.DOC Page 3
4.3 Files Needed to Build BOOT
BOOT.MAC
KLPRE.MAC
PMT.MAC
KSPRE.MAC
4.4 Instructions for Building BOOT
The procedure for building BOOT is complex. It is suggested that BOOT
only be built by submitting the Batch file BOOT.CTL.
4.5 Special Considerations
None.
5.0 INTERNAL CHANGES
Refer to BOOT.TCO for detailed information about changes. BOOT
version 6 is now capable of dumping up to 2 million words of core.
BOOT version 6 is also capable of dumping into a long file.
6.0 SUGGESTIONS
None.
[End of BOT6.DOC]