Trailing-Edge
-
PDP-10 Archives
-
bb-d549g-sb
-
rsx3.doc
There are 2 other files named rsx3.doc in the archive. Click here to see a list.
RSXT10.DOC -- V3(36)
March 1977
Copyright (C) 1977
Digital Equipment Corporation, Maynard, Mass.
This software is furnished under a license for use only on a single
computer system and may be copied only with the inclusion of the above
copyright notice. This software, or any other copies thereof, may not
be provided or otherwise made available to any other person except for
use on such system and to one who agrees to these license terms.
Title to and ownership of the software shall at all times remain in
DEC.
The information in this software is subject to change without notice
and should not be construed as a commitment by Digital Equipment
Corporation.
DEC assumes no responsibility for the use or reliability of its
software on equipment which is not supplied by DEC.
RSX3.DOC Page 2
RSXT10.DOC -- V3(36)
March 1977
1.0 SUMMARY
RSXT10 is a utility program to convert files from TOPS-10 and/or
DOS-11 file formats to RSX-11 formats.
Use of RSXT10 and file transfer procedures are described in the Guide
To Using the "FE" Device, USEFE.MEM. RSXT10 commands are described in
RSXFMT.HLP.
2.0 EXTERNAL CHANGES
None.
3.0 KNOWN BUGS AND DEFICIENCIES
As of this document, there are no known bugs or deficiencies.
4.0 INSTALLATION INSTRUCTIONS
4.1 Files Needed to Run RSXT10
RSXT10 consists of two files, RSXT10.EXE and RSXFMT.HLP.
4.2 Instructions for Installing RSXT10
Copy RSXT10 to SYS: and RSXFMT.HLP to HLP:.
4.3 Files Needed to Build RSXT10
RSXT10 is built from the following files:
RSXT10.MAC
4.4 Instructions for Building RSXT10
Type the following command:
SUBMIT RSXT10.CTL/TIME/UNIQ:0/REST
RSX3.DOC Page 3
4.5 Special Considerations
None.
5.0 INTERNAL CHANGES
Not applicable.
6.0 SUGGESTIONS
None.
[End of RSX3.DOC]