Google
 

Trailing-Edge - PDP-10 Archives - bb-h138e-bm_tops20_v6_1_distr - 6-1-documentation/actgen.doc
There are 19 other files named actgen.doc in the archive. Click here to see a list.


ACTGEN.DOC -- Changes from V4(3) to V5(3)
October 1981






























COPYRIGHT (C) 1976,1979,1982 BY
DIGITAL EQUIPMENT CORPORATION, MAYNARD, MASS.


THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY BE USED AND  COPIED
ONLY  IN  ACCORDANCE  WITH  THE  TERMS  OF  SUCH  LICENSE AND WITH THE
INCLUSION OF THE ABOVE COPYRIGHT NOTICE.  THIS SOFTWARE OR  ANY  OTHER
COPIES  THEREOF MAY NOT BE PROVIDED OR OTHERWISE MADE AVAILABLE TO ANY
OTHER PERSON.  NO TITLE TO AND OWNERSHIP OF  THE  SOFTWARE  IS  HEREBY
TRANSFERRED.

THE INFORMATION IN THIS SOFTWARE IS SUBJECT TO CHANGE  WITHOUT  NOTICE
AND  SHOULD  NOT  BE  CONSTRUED  AS  A COMMITMENT BY DIGITAL EQUIPMENT
CORPORATION.

DIGITAL ASSUMES NO RESPONSIBILITY FOR THE USE OR  RELIABILITY  OF  ITS
SOFTWARE ON EQUIPMENT WHICH IS NOT SUPPLIED BY DIGITAL.
ATG5.DOC                                                        Page 2


ACTGEN.DOC -- Changes from V4(3) to V5(3)
October 1981



1.0  SUMMARY

ACTGEN is an account generator program used to create and  install  an
account  validation  data  base  for  use  by  TOPS-20  in  validating
accounts.  It is intended primarily for use by the system manager  and
operator.

ACTGEN runs on TOPS-20 Release 5.

Wheel or operator capabilities must be enabled to run ACTGEN.

ACTGEN is documented in the TOPS-20 System Manager's Guide.



2.0  EXTERNAL CHANGES

None.



3.0  RESTRICTIONS AND DEFICIENCIES

There are no known  restrictions  or  deficiencies  in  ACTGEN  as  of
September 1, 1981.



4.0  INSTALLATION AND BUILD PROCEDURES


4.1  Files Needed to Run ACTGEN

ACTGEN consists of one file, ACTGEN.EXE.


4.2  Instructions for Loading and Installing ACTGEN

Mount the tape labeled  Installation  Tape  on  MTA0:   and  type  the
following commands:

     SKIP MTA0:5 FILES
     R DUMPER
     TAPE MTA0:
     REWIND
     DENSITY 1600-BPI
     SKIP 1
     RESTORE <*>ACTGEN.EXE (TO) SYS:*.*.-1
     REWIND
ATG5.DOC                                                        Page 3


4.3  Files Needed to Build ACTGEN

ACTGEN is built from the following files:

     ACTGEN.MAC

In addition, the following files must be on SYS::

     MACREL.REL
     MACSYM.UNV
     MONSYM.UNV


4.4  Instructions for Building ACTGEN

Mount the tape labeled  Distribution  Tape  on  MTA0:   and  type  the
following commands:

     R DUMPER
     TAPE MTA0:
     REWIND
     DENSITY 1600-BPI
     SKIP 1
     RESTORE <*>*.*.* (TO) <self>*.*.*
     REWIND
     ^C
     SUBMIT ACTGEN.CTL/TIME/UNIQ:0/REST



5.0  INTERNAL CHANGES

Refer to ACTGEN.TCO for detailed information about changes.



[End of ATG5.DOC]